181843M - Feed Dog / Metal
Fits same as to the left
Tip: Have found these need to be altered
Effects - proper stretch stitch/reverse feed
Not Recommended as a replacement
Requires modification to fit proper & not
strike the front of the needle plate
In Stock
 No Usually ships in 2-3 business days
Will be modified for
proper fit before shipping
$12.50
163713 - Feed Dog / Metal
Fits: 600 Series T&S with Metal Feeds
May fit those with Soft Touch Feeds, but
ensure needle plate is cut-out on the
underneath side.  May not fit 630 & 640
In Stock
 No Usually ships in 2-3 business days
$11.95
181843 - Soft Touch Feed Dog
Fits: 700 Series T&S
Futura 920, 925, Creative Touch 1030, 1036
Fits: Athena/Touch Tronic 2000, 2005, 1200
& 1060
Recommended Replacement
In Stock
 No Usually ships in 2-3 business days
$13.50
Counter
382405 Feed Dog  / Rubber (Soft Touch)
Fits Early Model Futura 900 - Some 920
Inspect your machine before ordering
& ensure you do not need 181843 instead
In Stock
 No Usually ships in 2-3 business days
$16.95
Second Time Around Parts
I do have some parts that fit various machines - see the 2nd Time Around Parts Page
163713R - Rubber Feed Dogs
Fits: 620 - 630 - 640 Series T&S
Otherwise known as "Soft Touch" Feed Dogs
In Stock
 No Usually ships in 2-3 business days
$16.85
383334M - Metal Feed Dogs
Fits: Touch Tronic 2001 - 2010
Not recommended, but available
In Stock
 No Usually ships in 2-3 business days
$15.95
383334R - Rubber Feed Dogs
Fits: Touch Tronic 2001 - 2010
In Stock
 Yes Usually ships in 2-3 business days
$12.50
PLEASE NOTE - METAL FEED DOG REPLACEMENT
Some users have reported problems when using the Metal Feed Dog replacements.
Mainly for item 181843M, the metal feed dog replacement for the Touch & Sew, Athena, and some Futura 920 machines.
They perform general sewing just fine - however - on the Athena for example, the little dog, flower, honeycomb,
and other stitches do not turn out as they use to with the original rubber feed dog.
Plus: 181843M does require modification to actually fit correctly.  In my 30 plus years, I have yet to install a pair that didn't  require modification.
The short of it, they are to long, the over all length needs to be reduced.  If you take a look at the picture for 181843M, you may notice that they
have a tapered angle on the front of the feeds.  That tapered area hits the front of the needle plate on maximum stitch length.
I do take the liberty to modify any set I sell before mailing them out.  The front angle area is removed to ensure a proper fit.
Other Feed Dogs To Be Added
E-Mail Me For Needs If Not Listed